|
NWOR's
new line of specially formulated polyurethane Toyota
spring bushings were introduced in '94. All pre-loads
and diametal interference are controlled to minimize
binding on mating surfaces. Our new tapered
shoulder seals out dirt and moisture. NWOR's splined
urethane bushings are grooved inside and out for maximum
lubrication retention. We have bushings for
both the factory spring, which is a metric width, and
aftermarket spring to ensure proper fit, maximum wear
and a quiet, smooth ride. We recommend our Waterproof
Grease 14 oz. (N69610) for use on these bushings.
|

SPRING
BUSHING KITS
Factory
Spring (Front) '79-'85 |
N80000 |
Factory
Spring (Rear) '79-'83 |
N80001 |
Factory
Spring (Rear) '84-'88 |
N80002 |
Factory
Spring (Rear) '89-'03 |
N80007 |
Lift
Spring (Front) '79-'85 |
N80003 |
Lift
Spring (Rear) '79-'83 |
N80004 |
Lift
Spring (Rear) '84-'88 |
N80005 |
Lift
Spring (Rear) '89-'03 |
N80008 |
Waterproof
Grease(14 oz.) |
N69510 |
FRAME
BUSHING KITS
These
urethane frame bushings fit in the Toyota's frame directly above
the shackle and eliminate the bushing noise so common with the Toyota
4x4.
Frame
Bushings '79-'88 |
N80070 |
Frame Bushings '86-'88 |
N80071 |
Frame
Bushings '89-'03 |
N80072 |
ULTRA-SLIDE®
SPRING INSERTS*
We
offer a special greaseable, teflon/polypropylene- based inner
leaf slider pad. The pad reduces inner
leaf friction at the spring tip since this area carries
the greatest amount of load. The greaseable "sliders" provide
a quieter and smoother ride on and off-highway.
They will retrofit all NWOR springs with an oval cut in the
spring tips. They can be re-greased on the truck taking less
than a minute per spring.
Ultra-Slide®
Spring Inserts (6 per kit) |
N80075 |
AVAILABLE
FACTORY INSTALLED ON ALL NWOR SPRINGS
PRODUCED AFTER 7/1/94
|

|